Surge Generator T-1005

 

Cable Fault Locator
  PREVIOUS NEXT
For fault location in L.T. and control cable.
For high voltage testing of L.T. cables.
Suitable to connect to Reflectometer for taking distance to the fault.
Good output power.
Compact and lightweight.
Suitable to operate on mains (220-230/240 VAC, 45Hz up to 60 Hz) or portable generator.
Rugged steel body.

DESCRIPTION

  • Instrument has been primarily designed to produce high voltage surges for pre-location of under ground cable fault in combination with Reflectometer T-510.

  • The surges produced help in pinpointing the fault and tracing the route of the cable when used with acoustic DIGIPOINT surge generator generates D.C. high voltage for pressure testing of the underground cables to find out faulty phase and the breakdown voltage with leakage current.

  • It can also be used as limited burn down instrument.

TECHNICAL SPECIFICATIONS

Physical
Dimension
450x450x450 mm (LxBxH).
Weight
60 Kg Approx.
General
Supply Voltage
220-230/240 VAC, 45Hz up to 60 Hz.
Output Voltage
0-5 KV DC.
Output Power
750 Joules on 5 K.V.
Auto Discharge
Built in.
Surge Timing
6 sec to 20 sec.
Signal Output
Built in for Reflectometer T-510(Time Domain Reflectometer).
Operation Condition
Operating Temperature
-10C to 50C
Storage Temperature
-10C to 50C
Protection
Standard Accessories
Zero Start Interlock.
Range Interlock.
Automatic Discharge.
Over Load Protection.
Thermal breakdown Protection.
Over current Protection.
High Voltage output cable -15 mts.
L.T. cable - 15 mts.
Earthing cable- 15 mts
Discharge Rod.
Discharge Rod lead- 5mts.

Note: Dimension and Weight are subject to change without compromising on the safety and electrical specifications.



SURGE GENERATOR SET

PRE-LOCATION SET

PINPOINTING SET

CABLE IDENTIFICATION SET

CIS

CABLE ROUTE TRACER

DC HIGH VOLTAGE SET